Replacement filters pack for the Osmio Zero-IP-II Portable Reverse Osmosis Water Filter System from Osmio Water for Hard water area.
Designed for hard water areas with hardness over 200 ppm.
If you have a hardness level over 250 Calcium Carbonate then you may need to change the carbon block and membrane more frequently than every 6 months. The unit is designed to shut off if there is blockage in the membrane or prefilters. As the system recirculates the rejected water from the membrane, the TDS level continually rises of the water entering the membrane filter. Therefore, for those with water of higher TDS, more frequent carbon block and membrane changes are likely. It is recommended to have at least a spare carbon filter and membrane on hand with the unit at all times.
Filter Stages:
1 - Quick-Change Sediment Filter 5μm: removes coarse particles, e.g. Sand, rust, chlorine, lime
2 - Quick-Change 1 mic Composite Carbon filter: removes chlorine and organic impurities, helps to inhibit limescale
3 - Quick-Change Membrane 50GPD: removes all pollutants and flavours to almost 100%
4 - Quick-Change Insertion Filters: Hygiene After-filter antibacterial: removes 99% of the bacteria and viruses and improves the taste
How to recycle and dispose of Osmio Zero water filters
Quick-Change activated carbon filter and Quick-Change membrane 50GPD filter: these two filters can be placed in plastics recycling. However, the bottom of the filters will first need to be cut open using a hacksaw. The carbon and membrane elements can then be removed and thrown into the bin before placing the filters in recycling.
Quick-Change Sediment filter: This can simply be placed into the plastics recycling.
Quick-Change Insertion filter: This filter should again be cut in half and the contents emptied out into the bin before recycling the plastic exterior.